2000 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor

Crankshaft Position Sensor (CKP) sensor is a pick-up coil that is mounted next to crankshaft pulley. Turn ignition off. Disconnect CKP sensor connector. Measure resistance between CKP sensor terminals. Replace CKP sensor if resistance is not as specified. See CRANKSHAFT POSITION SENSOR RESISTANCE  table.

CRANKSHAFT POSITION SENSOR RESISTANCE

Temperature °F (°C) Ohms
-14-122 (-10-50) 1630-2740
123-212 (51-100) 2065-3225
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.