Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
GS400, LS400 & SC400
TORQUE SPECIFICATIONS (GS400, LS400 & SC400)
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Coolant By-Pass Pipe Bolt | 13 (18) | |
| Fuel Inlet-To-Fuel Main Tube | 22 (30) | |
| Intake Manifold Bolt/Nut | 13 (18) | |
| Rear Coolant By-Pass Joint Nut | 13 (18) | |
| Starter Bolt | ||
| GS400 | 27 (37) | |
| LS400 & SC400 | 29 (39) | |
| Terminal Nut | 13 (18) | |
| Throttle Body Bolt/Nut | 13 (18) | |
| INCH Lbs. (N.m)Β | ||
| End Cover Bolt | 32 (3.6) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
