Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus SC 300FACTORY OEM SERVICE PROCEDURE
Test Procedure
- Engine and transmission must be at normal operating temperature. Start engine and check idle speed with transmission in Neutral with A/C off. Ensure idle speed is 650-750 RPM.
- Apply service and parking brakes. Using stop watch, measure time until engagement shock is felt when selector lever is shifted from "N" to "D". Allow one minute interval between tests. Perform time measurements 2 more times and calculate average value. Time should be less than 1.2 seconds.
- Use same procedure to test time lag when selector lever is moved from "N" to "R". Time lag should be less than 1.5 seconds.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
