2000 Lexus LX 470FACTORY OEM SERVICE PROCEDURE

Bench Testing: Rotor

  1. Check rotor for open field windings by using an ohmmeter across slip rings. Rotor resistance should be within specification. See ROTOR RESISTANCE SPECIFICATIONS  table.
  2. Check rotor for shorts to ground by connecting ohmmeter between slip ring and rotor shaft. Ohmmeter should indicate no continuity. Check slip rings for wear or pitting. Standard slip ring diameter is .559-.567" (14.2-14.4 mm). Turn slip rings on lathe if necessary. Minimum slip ring diameter is .504" (12.8 mm).
ROTOR RESISTANCE SPECIFICATIONS

Application (1) Ohms
Avalon 2.1-2.5
Camry & Camry Solara
4-Cyl. 2.7-3.1
V6 2.1-2.5
Land Cruiser, MR2, Sienna, Tacoma, Tundra & 4Runner 2.1-2.5
All Other Models 2.7-3.1
(1) Specification given is with temperature at 68°F (20°C).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.