Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus LX 470FACTORY OEM SERVICE PROCEDURE
Bench Testing: Brushes
- Brushes should slide smoothly in holders. Replace brushes if damaged or worn. On ECHO, MR2, Tundra and 4Runner, new brush exposed length should be .374-.453" (9.5-11.5 mm). On all other models, new brush exposed length should be .413" (10.5 mm).
- On all models, minimum exposed length should be more than .059" (1.5 mm). There are 2 different brush holders used. One brush holder is replaced as an assembly, and the other has replaceable brushes. If exposed brush length is less than minimum, replace brushes or brush holder assembly. Install new brush springs when replacing brushes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
