2000 Lexus LX 470FACTORY OEM SERVICE PROCEDURE

Abs Warning Light: Testing

  1. Inspect ABS warning light bulb. Replace as needed. If bulb is okay, remove ABS solenoid relay from underhood relay box. See Figure. Check continuity between specified terminals. See ABS SOLENOID RELAY CONTINUITY  table. Replace as needed. If relay is okay, go to next step.
    ABS SOLENOID RELAY CONTINUITY

    Terminal No. (1) Continuity
    Static Test
    1 & 3 No
    2 & 3 Yes
    4 & 6 Yes (80 ohms)
    5 & 3 Yes
    3 & 5 (Reversed) No
    Battery Voltage Applied To Terminals No. 4 & 6
    1 & 3 Yes
    2 & 3 No
    (1) See Fig 1.
  2. Inspect circuit between DLC1, ABS solenoid relay and ground for open. Repair as needed. See WIRING DIAGRAMS . If circuit okay, go to next step.
  3. Inspect ABS ECU harness connectors. Ensure connectors are clean and tight. Repair as needed. Check if any DTC are present. See RETRIEVING DIAGNOSTIC TROUBLE CODES . Diagnose and repair DTC that are present. If no DTC are present, go to next step.
  4. Ensure short pin is installed in DLC1. Turn ignition on. Monitor ABS warning light when short pin is removed. If light is not illuminated, go to next step. If light remains illuminated, inspect Pink/Blue wire between ABS ECU, DLC1 and warning light for short to ground. Repair as needed.
  5. Reinspect ABS solenoid relay. Go to step  1. If solenoid is okay, inspect circuit between ABS solenoid relay and DLC1. See WIRING DIAGRAMS .
Fig 1: Testing ABS Solenoid Relay
G98G07844Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.