Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus LX 470FACTORY OEM SERVICE PROCEDURE
Pattern Select Switch
- Check pattern select switch light operation. Turn ignition on. Ensure pattern select switch (PWR) indicator light is on when switch is pushed to ON position. Ensure PWR indicator light is off when switch is pushed to OFF position. If indicator light operates as described, go to next step. If indicator light does not operate as described, inspect and repair wiring harness as necessary. If wiring harness is okay, replace indicator bulb.
- Turn ignition on. Using a DVOM, backprobe ECM connector. Measure voltage between terminal PWR at ECM harness connector and ground. See Figure or Figure . Voltage should be 1.5 volts with pattern select switch in PWR position. Voltage should be 7.5-14 volts or less with pattern select switch in NORMAL position. If voltage is not as specified, go to next step. If voltage is as specified, inspect and repair wiring harness between pattern select switch and ECM. If wiring harness is okay, replace pattern select switch.
- Turn ignition off. Disconnect pattern select switch connector. Using ohmmeter, ensure continuity exists between switch connector terminals No. 3 and 5 with switch in PWR position. See Figure. No continuity should exist with switch in NORM position. If continuity is not as specified, replace pattern select switch. If continuity is as specified, inspect and repair wiring harness between battery and pattern select switch, and between pattern select switch and ECM. If wiring harness is okay, replace ECM and retest.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
