2000 Lexus LS 400FACTORY OEM SERVICE PROCEDURE

Multiplex Control DTCS

MULTIPLEX DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION

DTC Description
B1211/11 Driver's Door ECU To Body ECU Communication
B1212/12 Passenger's Front Door ECU To Body ECU Communication
B1213/13 Tilt/Telescopic ECU To Body ECU Communication
B1214/14 Door System Bus Communication Circuit Is Short To Power
B1215/15 Door System Bus Communication Circuit Short To Ground
B1216/16 Right Rear Door ECU To Body ECU Communication
B1217/17 Left Rear Door ECU To Body ECU Communication
B1221/21 Power Window Master Switch Circuit
B1222/22 Driver's Door Lock Control Switch Circuit
B1223/23 Passenger's Front Window Switch Circuit
B1224/24 Passenger's Door Lock Control Switch Circuit
B1225/25 Right Rear Window Switch Circuit
B1226/26 Left Rear Window Switch Circuit
B1231/31 Driver's Jam Protection Limit Switch Circuit
B1232/32 Driver's Jam Protection Pulse Switch Circuit
B1233/33 Passenger's Front Jam Protection Limit Switch Circuit
B1234/34 Passenger's Front Jam Protection Pulse Switch Circuit
B1235/35 Right Rear Jam Protection Limit Switch Circuit
B1236/36 Right Rear Jam Protection Pulse Switch Circuit
B1237/37 Left Rear Jam Protection Limit Switch Circuit
B1238/38 Left Rear Jam Protection Pulse Switch Circuit
B1241/41 Body ECU Switch Circuit Diagnosis
B1242/42 Wireless Door Lock Tuner Circuit Malfunction
B1243/43 GSW Terminal Circuit Malfunction
B1244/44 Light Sensor Circuit Malfunction
B1261/61 ECM To Body ECU Communication
B1262/62 A/C Control Assembly To Body ECU Communication
B1266/66 Instrument Panel System Bus Communication Circuit Short To Power
B1267/67 Instrument Panel System Bus Communication Circuit Short To Ground
B1271/71 Combination Meter ECU To Body ECU Communication
B1272/72 Power Seat ECU (W/Memory Seat) To Body ECU Communication
B1273/73 Sliding Roof Control Relay To Body ECU Communication
B1275/75 Accessory Bus Buffer To Body ECU Communication
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.