2000 Lexus LS 400FACTORY OEM SERVICE PROCEDURE

Automatic A/C-Heater Systems: Programming: Initialization: Automatic

Automatic initializing occurs when battery is reconnected and ignition switch is first turned from OFF to ON position. When battery is reconnected and ignition switch is first turned from ON to OFF position. Initializing will also occur when A/C control assembly has detected battery voltage reduction 30 times and 60 seconds has elapsed since ignition switch was turned from ON to OFF position.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.