2000 Lexus GS 400FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Motors

MOTORS

Component Component Location
ABS, TRAC & VSC Actuator (3.0L) At left rear corner of engine compartment. See Figure.
ABS, TRAC & VSC Actuator (4.0L) At left rear corner of engine compartment. See Figure.
A/C Condenser Fan Motor (3.0L) In front of left side of radiator. See Figure.
A/C Condenser Fan Motor (4.0L) In front of left side of radiator. See Figure.
Air Inlet Control Servo Motor Behind right side of dash.
Air Mix Control Servo Motor (Driver Side) Behind center of dash.
Air Mix Control Servo Motor (Front Passenger Side) Behind right side of dash.
Air Vent Mode Control Servo Motor Behind right side of dash.
Auto Antenna Control Relay & Motor At right side of luggage compartment. See Figure.
Blower Motor Behind lower right side of dash.
Front Wiper Motor (3.0L) On left side of firewall. See Figure.
Front Wiper Motor (4.0L) On left side of firewall. See Figure.
Fuel Lid Opener Motor At left side of luggage compartment.
Fuel Pump & Sender In fuel tank.
Headlight Cleaner Motor (3.0L) At left front corner of engine compartment, behind headlight. See Figure.
Headlight Cleaner Motor (4.0L) At left front corner of engine compartment, behind headlight. See Figure.
Radiator Fan Motor (3.0L) At left front of engine compartment. See Figure.
Radiator Fan Motor (4.0L) At left front of engine compartment. See Figure.
Throttle Control Motor (3.0L) On throttle body. See Figure.
Throttle Control Motor (4.0L) On throttle body. See Figure.
Washer Motor (3.0L) At left front corner of engine compartment. See Figure.
Washer Motor (4.0L) At left front corner of engine compartment. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.