Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus GS 400FACTORY OEM SERVICE PROCEDURE
Multiplex Control Systems
- Description & Operation
- Trouble Shooting
- Self-Diagnostics
- Diagnostic Tests
- Test No. 1: Body No. 1 Ecu To Driver's Door Ecu Communication
- Test No. 2: Body No. 1 Ecu To Passenger's Door Ecu Communication
- Test No. 3: Body No. 1 Ecu To Tilt/Telescopic Ecu Communication
- Test No. 4: Door System Comm. Bus Short To Battery Voltage Or Door System Comm. Bus Shorted To Ground
- Test No. 5: Body No. 1 Ecu To Right Rear Door Ecu Communication
- Test No. 6: Body No. 1 Ecu To Left Rear Door Ecu Communication
- Test No. 7: Body No. 2 Ecu Communication Problem
- Test No. 8: Switch Circuit Communication Problem
- Test No. 9: Limit Switch Circuit Communication Problem
- Test No. 10: Pulse Switch Circuit Communication Problem
- Test No. 11: Remote Keyless Entry Circuit Problem
- Test No. 12: GSW Terminal Circuit Problem
- Test No. 13: Light Sensor Circuit Problem
- Test No. 14: Body No. 2 Ecu To P1 Switch Circuit Problem
- Test No. 15: Body No. 1 Ecu To ECM Communication Problem
- Test No. 16: Body No. 1 Ecu To A/C Control Communication
- Test No. 17: Combination Meter (Instrument Cluster) Communication Bus Shorted
- Test No. 18: Combination Meter (Instrument Cluster) Ecu Communication
- Test No. 19: Power Seat Ecu Communication
- Test No. 20: Sliding Roof Ecu Communication
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
