2000 Lexus ES 300FACTORY OEM SERVICE PROCEDURE

Engine Coolant Temperature (ECT) Sensor

  1. Ensure ignition is off. Note location of ECT sensor. See ENGINE COOLANT TEMPERATURE (ECT) SENSOR LOCATIONΒ  table. Remove ECT sensor.
  2. Place probe end of ECT sensor and thermometer in container of water. Attach ohmmeter between ECT sensor terminals. Heat water and note that resistance is within specification in relation to temperature. See Fig 1. Replace ECT sensor if resistance is not within specification.
  3. Using NEW gasket, install ECT sensor. Tighten ECT sensor to 15 ft. lbs. (20 N.m). Fill cooling system.
ENGINE COOLANT TEMPERATURE (ECT) SENSOR LOCATION

Model Location
ES300 On Coolant Housing In Front Of Intake Manifold, At Timing Belt End Of Engine & Contains Dark Gray 2-Pin Connector With Green/Black & Brown Wires
RX300 On Coolant Housing In Front Of Intake Manifold, At Timing Belt End Of Engine & Contains Dark Gray 2-Pin Connector With Green/White & Brown Wires
Fig 1: Testing Engine Coolant Temperature (ECT) Sensor
G95D32501Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.