Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus ES 300FACTORY OEM SERVICE PROCEDURE
Power Window System
- Automatic Operation
To partially lower driver's window, press button slightly and hold until window is at desired level. To fully lower window without having to hold button down, press button down firmly and release. Automatic operation is controlled by a logic circuit in master switch. - Key Off Operation
The windows can be operated for about 45 seconds after ignition is turned off, or until either front door has been opened. This function is referred to as key off operation. - Door Key Cylinder Operation
The windows can be operated using key in driver's door key cylinder. To close windows, insert key in driver's door key cylinder, turn key counterclockwise and hold. To open windows, turn key clockwise and hold. - Catching Prevention (Jam Function)
In the event an object is caught in area of window travel during upward movement, power window motor will reverse direction as a safety measure. If window encounters resistance when window opening is greater than 7.874" (200 mm), window will automatically stop and lower an additional 1.969" (50 mm) and stop. If window encounters resistance when window opening is 7.874" (200 mm) or less, window will automatically lower until opening is 7.874" (200 mm) and stop.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
