1999 Lexus GS 400FACTORY OEM SERVICE PROCEDURE

Power Window Master Switch/Driver Door Lock Control Switch Circuit

NOTE: If LEXUS scan tool is available, start test from step  1. If this scan tool is not available, start test from step  2.
  1. Using scan tool, check for DTC B1221. If DTC B1221 is retrieved, go to next step. If DTC B1221 is not retrieved, go to next test listed in appropriate SYMPTOM DIAGNOSIS table under TROUBLE SHOOTING .
  2. Check power window master switch. See DOOR LOCK CONTROL SWITCH  under COMPONENT TESTS. Replace switch as necessary. Retest system operation. If switch is okay, go to next step.
  3. Check circuits for faults between power window master switch and driver door ECU. See WIRING DIAGRAMS . Repair or replace as necessary. If circuits are okay, go to next test listed in appropriate SYMPTOM DIAGNOSIS table under TROUBLE SHOOTING .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.