1998 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Fuel System Pressure Release

  1. Disconnect electrical connector from fuel pump. Fuel pump is located in the fuel tank. Start engine and allow engine to idle until engine stalls. Turn ignition off. Disconnect negative battery cable.
  2. Place suitable container under any easily accessible fuel line connection. Cover fuel line connection with shop towel. Slowly loosen fuel line connection, allowing fuel pressure to be released. If disconnecting quick connector, see FUEL LINE QUICK CONNECTORΒ . Once fuel pressure is released, fuel system components may be serviced.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.