1998 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Throttle Position (TP) Sensor: Es300

  1. Manufacturer does not list procedure for Throttle Position (TP) sensor adjustment at time of publication. Only information available is for checking resistance of TP sensor.
  2. Disconnect electrical connector from TP sensor. Note electrical terminals on TP sensor. See Fig 1. Apply vacuum to throttle opener.
  3. Using ohmmeter, check resistance between specified terminals in relation to throttle position. See THROTTLE POSITION SENSOR RESISTANCE (ES300)Β  table. Replace components as necessary if resistance is not within specification.
THROTTLE POSITION SENSOR RESISTANCE (ES300) (1)

Throttle Position Terminals Ohmmeter Reading
Fully Closed VTA & E2 200-6,300
Fully Open VTA & E2 2,000-10,200
" VC & E2 2,500-5,900
(1) Apply vacuum to throttle opener before checking TP sensor.
Fig 1: Identifying Electrical Terminals On TP Sensor (ES300)
G97C06282Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.