1997 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Section 14 (Generator & Regulator): Specifications

WARNING: This page is about a different car, the 1997 Lexus SC 300. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Part tightened N.m kgf.cm ft.lb
Bearing retainer x Drive end frame 3.0 31 27 in.lb
Rectifier end frame without wire clip x Drive end frame 4.5 46 40 in.lb
Generator pulley x Rotor 110.5 1,125 81
Rectifier holder x Lead wire on rectifier end frame 2.9 30 26 in lb
Voltage regulator x Rectifier end frame 1.96 20 17 in.lb
Voltage regulator x Rectifier holder 1.96 20 17 in.lb
Brush holder x Rectifier holder 1.96 20 17 in.lb
Brush holder x Voltage regulator 1.96 20 17 in.lb
Rear end cover x Rectifier holder 4.4 45 39 in.lb
Plate terminal x Rectifier holder 3.8 39 34 in.lb
Terminal insulator x Rectifier holder 6.5 66 58 in.lb
Generator x Cylinder block 39 400 29
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.