Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
Electrical Component Locations
WARNING: This page is about a different car, the 1997 Lexus SC 300. However, it is still accessible from the selected car via links, so may be relevant.
ELECTRICAL COMPONENT LOCATIONS
| Component | Location | |
|---|---|---|
| Clutch Switch | Above Clutch Pedal | |
| Cruise Control ECU | Under Instrument Panel, Near Left Kick Panel | |
| Data Link Connector (DLC) No. 2 | Under Left Side Of Instrument Panel | |
| Engine/Transmission ECM | Under Right Front Floor Mat | |
| Neutral Start Switch | In Console | |
| Parking Brake Switch | Near Parking Brake Pedal (Or Lever) | |
| Speed Sensor | ||
| Except A/T | On Right Side Of Transmission | |
| A/T | Behind Center Console | |
| Stoplight Switch | Above Brake Pedal | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
