1997 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Test 12: Indicator Light Circuit

WARNING: This page is about a different car, the 1997 Lexus SC 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition on. Check voltage at ECU connector terminal No. 7. With main cruise control switch on, 10-16 volts should exist. With main cruise control switch off, less than 1.2 volts should exist. If voltage is as specified, go to next test in table. If voltage is not as specified, go to next step.
  2. Disconnect connector "D" from instrument cluster. See Fig 1. Connect jumper wire between ground and terminal No. 3 of disco nnected instrument cluster connector (instrument cluster side of connector). Turn ignition on. If CRUISE indicator light does not come on, go to next step. If CRUISE indicator light comes on, check for faulty circuit between instrument cluster and cruise control ECU. Repair circuit if necessary. If circuit is okay, replace cruise control ECU.
  3. Check bulb and replace if necessary. If bulb is okay, replace instrument cluster circuit plate (printed circuit).
Fig 1: Identifying Instrument Cluster Connector Terminals
G97G06175Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.