Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test 26: Washer Level Warning Light Problem
Disconnect instrument panel connector "D". Ground instrument panel connector "D" terminal No. 5 and turn ignition on. If light does not illuminate, repair wiring between instrument panel connector "D" terminal No. 5 and generator. Check light bulb. Replace as needed and retest. Check washer level switch. See WASHER LEVEL WARNING SWITCH under COMPONENT TESTS. Replace as needed and retest. If switch is okay, replace power source unit.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.