Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
Memory Set Switch Circuit
- Remove tilt and telescopic control module and leave harness connectors connected. With ignition off, measure voltage between tilt and telescopic control module connector T10, terminals No. 8 and No. 11. See Figure. With memory set switch on, voltage should be less than one volt. With memory set switch off, voltage should be 10-14 volts. If voltage is not as specified, go to next step. If voltage is as specified, go to TROUBLE SHOOTINGΒ and identify next circuit to be checked.
- Disconnect driving position memory and return switch connector. Measure resistance between memory and return switch connector terminals No. 3 and No. 4. See Fig 1. With memory set switch on, continuity should exist between measured terminals. With memory set switch off, resistance should be more than one megaohm. If resistance is as specified, go to next step. If resistance is not as specified, replace memory and return switch and retest system.
- Check and repair wiring harness and connectors between tilt and telescopic control module and memory and return switch. If wiring harness and connectors are okay, replace tilt and telescopic control module and retest system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
