1997 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Test 8: Es300

Disconnect vacuum hose to EGR valve. Using a hand-held vacuum pump, apply 5 in. Hg to EGR valve. Vacuum should hold and EGR valve should remain open. Release vacuum, EGR valve should close. Check for binding or sticking EGR valve. Clean or replace as necessary.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.