1997 Lexus SC 300 AutomaticFACTORY OEM SERVICE PROCEDURE

Clutch Switch

  1. Ensure pedal height, free play and push rod play are correct. Verify engine does not start when clutch pedal is released. Ensure engine starts when clutch pedal is fully depressed.
  2. If system is not operating correctly, ensure continuity exists between clutch switch terminals when switch is depressed and does not exist when between clutch switch terminals when switch is released. See Fig 1. Replace or adjust clutch switch as necessary.
Fig 1: Checking Clutch Start System
G94I47496Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.