Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Lexus LX 450FACTORY OEM SERVICE PROCEDURE
Wheel Angle
- Remove the caps of the knuckle stopper bolts and check the steering angles. See Fig 1.
- Turn the steering wheel fully, and measure the turning angle. See Fig 2 and Figure. If maximum steering angles differ from the standard value, adjust the wheel angle with the knuckle stopper bolts. If the wheel angle still cannot be adjusted within limits, inspect and replace damaged or worn steering parts.
NOTE:
When the steering wheel is fully turned, make sure that the wheel is not touching the body or brake flexible hose.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
