1997 Lexus GS 300FACTORY OEM SERVICE PROCEDURE

Test 20: Shift Position Indicator Problem

Disconnect instrument panel connector "A". Turn ignition on. While moving shifter, check voltage at terminals listed. See SHIFT POSITION INDICATOR TERMINALΒ  table. If voltage does not exist, check wiring between instrument panel connector terminal listed and shift position switch. Check switch. If wiring and switch are okay, check light bulb. Replace as needed and retest. If voltage exists, replace circuit plate and retest.

SHIFT POSITION INDICATOR TERMINAL

Position Connector/Terminal No.
Park A/1
Reverse A/2
Neutral A/3
Drive A/4
2ND A/5
LOW A/6
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.