Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
Engine Controls - Tests W/Codes
- Introduction
- Self-Diagnostic System
- Scan Tester Problems
- Summary
- Circuit Tests
- Notes
- DTC P0100 - Mass Airflow (MAF) Sensor Circuit
- DTC P0101 - Mass Airflow (MAF) Sensor Circuit Range/Performance Problem
- DTC P0110 - Intake Air Temperature (IAT) Sensor Circuit
- DTC P0115 - Engine Coolant Temperature (ECT) Sensor Circuit
- DTC P0116 - Engine Coolant Temperature (ECT) Sensor Circuit Range/Performance Problem
- DTC P0120 - Throttle Position (TP) Sensor Circuit Malfunction
- DTC P0121 - Throttle Position (TP) Sensor Circuit Range/Performance Problem
- DTC P0125 - Insufficient Coolant Temperature For Closed Loop Fuel Control
- DTC P0130 - Heated Oxygen Sensor Fault (Bank No. 1, Sensor No. 1) DTC P0150 - Heated Oxygen Sensor Fault (Bank No. 2, Sensor No. 1)
- DTC P0133 - Heated Oxygen Sensor (Bank No. 1, Sensor No. 1) Circuit Slow Response DTC P0153 - Heated Oxygen Sensor (Bank No. 2, Sensor No. 1) Circuit Slow Response
- DTC P0135 - Heated Oxygen Sensor Circuit (Bank No. 1, Sensor No. 1) DTC P0141 - Heated Oxygen Sensor Circuit (Bank No. 1, Sensor No. 2) DTC P0155 - Heated Oxygen Sensor Circuit (Bank No. 2, Sensor No. 1) DTC P0161 - Heated Oxygen Sensor Circuit (Bank No. 2, Sensor No. 2)
- DTC P0136 - Heated Oxygen Sensor Circuit (Bank No. 1, Sensor No. 2) DTC P0156 - Heated Oxygen Sensor Circuit (Bank No. 2, Sensor No. 2)
- DTC P0141 - Heated Oxygen Sensor Circuit (Bank No. 1, Sensor No. 2)
- DTC P0150 - Heated Oxygen Sensor Fault (Bank No. 2, Sensor No. 1)
- DTC P0153 - Heated Oxygen Sensor (Bank No. 2, Sensor No. 1) Circuit Slow Response
- DTC P0155 - Heated Oxygen Sensor Circuit (Bank No. 2, Sensor No. 1)
- DTC P0156 - Heated Oxygen Sensor Circuit (Bank No. 2, Sensor No. 2)
- DTC P0161 - Heated Oxygen Sensor Circuit (Bank No. 2, Sensor No. 2)
- DTC P0171 - System Too Lean (Fuel Trim), DTC P0172 - System Too Rich (Fuel Trim)
- DTC P0300 - Random Misfire Detected
- DTCS P0301-P0308 - Cylinders No. 1-8 Misfire Detected
- DTC P0325 - Knock Sensor No. 1 Circuit, DTC P0330 - Knock Sensor No. 2 Circuit
- DTC P0335 Or P1335 - Crankshaft Position (CKP) Sensor Circuit
- DTC P0340 - Camshaft Position (CMP) Sensor Circuit
- DTC P0401 - Insufficient Exhaust Gas RECIRCULATION (EGR) Flow Detected
- DTC P0402 - Excessive EGR Flow Detected
- DTC P0403 - EGR Circuit Malfunction
- DTC P0420 Or P0430 - Catalyst System Efficiency Below Threshold
- DTC P0441 - Incorrect EVAP Purge Flow
- DTC P0500 - Vehicle Speed Sensor (VSS) Malfunction
- DTC P0505 - Idle Control System Malfunction
- DTC P0510 - Closed Throttle Position (CTP) Switch Malfunction
- DTCS P1100 - Barometric Pressure (BARO) Sensor Circuit Malfunction
- DTC P1200 - Fuel Pump Relay Circuit Malfunction
- DTC P1300 Or P1305 - IGNITOR Circuit Malfunction
- DTC P1335 - Crankshaft Position (CKP) Sensor Circuit
- DTC P1400 - Sub-Throttle Position (Sub-TP) Sensor Malfunction
- DTC P1401 - Sub-Throttle Position (Sub-TP) Sensor Circuit Range/Performance Problem
- DTC P1500 - Starter Signal Circuit Malfunction
- DTC P1600 - ECM Batt Malfunction
- DTC P1605 - Knock Control ECM Malfunction
- DTC P1780 - Park/Neutral Position Switch Malfunction
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.