Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1996 Lexus SC 300 AutomaticFACTORY OEM SERVICE PROCEDURE

Idle Air Control Valve

IDLE AIR CONTROL (IAC) VALVE RESISTANCE ⁽¹⁾

Application

Ohms

Cold ⁽²⁾

15-25

Hot ⁽³⁾

20-30

⁽¹⁾	Measure resistance between terminal B1 and terminals S1 and S3. Also, measure resistance between terminal B2 and terminals S2 and S4.

⁽²⁾	IAC valve temperature of 14-122°F (-10-50°C).

⁽³⁾	IAC valve temperature of 123-212°F (51-100°C).

Chapter Navigation

Return to Chapter: Sensor Operating Range Specifications

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.