Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Lexus LX 450FACTORY OEM SERVICE PROCEDURE
Engine Idle Speed Remains High
- Check for defective throttle linkage or cable.
- Check dashpot or throttle opener (if equipped).
- Check idle-up vacuum switching valve (if equipped) and wiring.
- Check idle air control valve (if equipped) and wiring.
- Check Throttle Position (TP) sensor and wiring.
- Check A/C signal circuit to Engine Control Module (ECM).
- Check park/neutral position switch signal to Engine Control Module (ECM).
- Check cold start injector system (if equipped).
- Check fuel injectors.
- Check Engine Control Module (ECM) and wiring.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
