Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Lexus LX 450FACTORY OEM SERVICE PROCEDURE
Ignition Switch Continuity Test
WARNING:
Deactivate air bag system before performing any service operation. For 1996 LX450, see AIR BAG RESTRAINT SYSTEM
article in ACCESSORIES & EQUIPMENT.
- Disconnect negative battery cable. Remove driver side lower instrument panel cover. Remove upper and lower steering column covers if needed. Locate ignition switch wiring harness 10-pin connector. See Fig 1.
- With ignition switch in LOCK position, there should be no continuity between any terminals. With ignition switch in ACC position, there should be continuity between terminals No. 7 and 9. With ignition switch in ON position, there should be continuity between terminals No. 3 and 4, and between terminals No. 6, 7 and 9. With ignition switch in START position, there should be continuity between terminals No. 2, 3 and 4, and between terminals No. 6, 9 and 10. If continuity is not as specified, replace switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.