1996 Lexus LX 450FACTORY OEM SERVICE PROCEDURE

Abs Control Relay

  1. Remove ABS control relay. See Figure. Using a DVOM, check continuity between specified terminals. Continuity should exist between terminals No. 9 and 10. Continuity should not exist between terminals No. 7 and 8. See Figure. If continuity is not as specified, replace relay.
  2. Using fused jumper wire, connect positive battery terminal to terminal No. 10. Connect negative battery terminal to terminal No. 9. Continuity should exist between terminals No. 7 and 8. If continuity is not as specified, replace relay. Disconnect battery. Continuity should exist between terminals No. 1 and 9. Continuity should not exist between terminals No. 2 and 5.
  3. Using ohmmeter capable of testing diodes, check for continuity between terminals No. 4 and 5. Transpose ohmmeter leads. Repeat measurement. If continuity exists or circuit is open for both measurements, actuator diode is defective. Replace relay, then go to next step. If continuity exists for only one measurement, relay is okay.
  4. Using fused jumper wire, connect positive battery terminal to terminal No. 1. Connect negative battery terminal to terminal No. 9. Continuity should exist between terminals No. 2 and 5. Continuity should not exist between terminals No. 2 and 6. Replace relay if operation is not as specified.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.