Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Lexus LS 400FACTORY OEM SERVICE PROCEDURE
Test No. 6, Driver's Door Switch Circuit
- Remove appropriate door panel to access door key lock and unlock switch 3-pin connector. Disconnect 3-pin connector. Check for continuity between terminals No. 1 and 2. See Fig 1. Continuity should exist with door key lock and unlock switch in LOCK position. Check for continuity between terminals No. 2 and 3. Continuity should exist with door key lock and unlock switch in LOCK position. If continuity is as specified, go to next step. If continuity is not as specified, replace door lock assembly.
- Disconnect driver's memory switch 7-pin connector. Check for continuity between specified terminals of driver's memory switch. See Fig 2. See DRIVER'S MEMORY SWITCH TEST table. If continuity is as specified, go to next step. If continuity is not as specified, replace driver's memory switch.
- Disconnect shoulder belt adjusting switch 7-pin connector. Check for continuity between terminals No. 2 and 3. See Fig 2. Continuity should exist with switch in UP position. Check for c ontinuity between terminals No. 1 and 3. Continuity should exist with switch in DOWN position. If continuity is not as specified, replace shoulder belt adjusting switch. If continuity is as specified, repair or replace wiring between each switch and driver's door ECU.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
