1996 Lexus ES 300FACTORY OEM SERVICE PROCEDURE

Power Window Master Switch: Illumination

  1. Set the window lock switch to the unlock position.
  2. Connect the positive (+) lead from the battery to terminal 8 and the negative (-) lead to terminal 4, and check that all the illuminations light up. See Fig 1.
  3. Set the window lock switch to the lock position, check that all the passenger's power window switch illuminations go out. See Fig 2. If operation is not as specified, replace the master switch.
Fig 1: Testing Power Window Master Switch Illumination (1 Of 2)
G00148034Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.