Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
Shift Lock Solenoid
- Disconnect electrical connector from shift lock solenoid. Using ohmmeter, measure resistance between shift lock solenoid terminals. See WIRING DIAGRAMS .
- Replace shift lock solenoid if resistance is not within specification. SeeSHIFT LOCK SOLENOID RESISTANCE SPECIFICATIONS table. Apply battery voltage between shift lock solenoid terminals. Replace shift lock solenoid if operating sound cannot be heard.
SHIFT LOCK SOLENOID RESISTANCE SPECIFICATIONS
| Application | Ohms |
|---|---|
| Avalon, Camry, Paseo, Tacoma (A-43D) & Tercel | 30-35 |
| Celica, Corolla, 1995 ES300, GS300, MR2 & 1996 4Runner | 21-27 |
| Land Cruiser, LS400, LX450, SC300, SC400, Supra & Tacoma (A-340E/F) | 20-28 |
| 1996 ES300, Pickup & 1995 4Runner | 29-36 |
| RAV4 | 26-33 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.