Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
Exhaust Gas RECIRCULATION (EGR) System
NOTE:
DO NOT
warm the engine until specified. Some testing must be performed when engine is cold.
- Ensure coolant temperature is less than 127°F (53°C). Start engine. Shift transmission into Neutral. Block wheels. Connect Jumper Wire (09843-18020) between terminals TE1 and E1 of DLC No. 1. See Figure.
- Run engine at 3500 RPM. See CONNECTING TACHOMETER under INTRODUCTION. Ensure coolant temperature is less than 127°F (53°C).
- While engine is running at 3500 RPM, disconnect jumper wire and observe engine RPM. If engine speed remains steady, go to next step. If engine speed does not remain steady, check for faulty EGR system components.
- Ensure engine coolant temperature is at least 131°F (55°C). Reconnect jumper wire between terminals TE1 and E1. While engine is running at 3500 RPM, disconnect jumper wire and observe engine RPM. If engine speed remains steady, EGR system is okay. If engine speed does not remain steady, check for faulty EGR system components.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
