1995 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Ecu Power Circuit Test

Turn remote door lock main switch to ON position. Leave electrical connector attached to remote door lock ECU. Check voltage at the following terminal of remote door lock ECU (backprobe the terminal). If battery voltage is not present, check for faulty fuse, main switch or wiring.

  • Terminal No. 1. See Fig 1.
Fig 1: Identifying Remote Door Lock ECU Terminals
G94G47189Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.