Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Lexus SC 300 AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Clutch Cover-To-Flywheel Bolts | 14 (19) | |
| Clutch Line | 11 (15) | |
| Clutch Line Union Bolt | 18 (25) | |
| Flywheel-To-Crankshaft Bolts | 54 (74) | |
| Front Exhaust Pipe | 32 (43) | |
| Rear Engine Mounting Member | ||
| Nuts | 10 (13) | |
| Bolts | 19 (26) | |
| Release Fork Support Bolt | 29 (39) | |
| Starter Bolts | 29 (39) | |
| Transmission Shift Lever Bolts | 14 (19) | |
| Transmission-To-Engine Bolts | ||
| 10-mm | 27 (37) | |
| 12-mm | 53 (72) | |
| INCH Lbs. (N.m) | ||
| Bleeder Plug | 71 (8) | |
| Master Cylinder Nut | 96 (12) | |
| Release Cylinder Bolt | 96 (12) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.