1995 Lexus LS 400FACTORY OEM SERVICE PROCEDURE

Check Mode Code Retrieval (Lexus Scan Tester Only)

  1. Ensure vehicle battery is fully charged. Apply parking brake. Shift transmission/transaxle into Neutral (M/T) or Park (A/T). Turn A/C and all accessories off. Ensure throttle is in idle position.
  2. Turn ignition off. Connect scan tester to Data Link Connector (DLC) No. 3. See Figure. DLC No. 3 connector is located in fuse box at lower left of instrument panel. Turn ignition on with engine off. Turn scan tester on.
  3. Switch scan tester from Normal Mode to Check Mode. Check Mode is operational if MIL on instrument panel flashes. Start engine. Ensure MIL goes off. Try to simulate conditions of driveability complaint described by customer.
    NOTE: If ignition is turned from ON to ACC or OFF position, all trouble codes and freeze frame data will be erased. DO NOT switch modes until all trouble codes and freeze frame data are recorded.
  4. Record any trouble codes and freeze frame data displayed for system diagnosis. If driveability problem exists and no codes are present, go to TESTS W/O CODES article for diagnosis by symptom.
  5. If any trouble codes are present, perform appropriate diagnostic test. See TROUBLE CODE IDENTIFICATION  table. For more information on freeze frame data, see FREEZE FRAME DATA under INTRODUCTION. For information on 2-trip detection logic codes, see TWO-TRIP DETECTION LOGIC  under INTRODUCTION.
  6. After repairs for trouble code have been completed, trouble code must be cleared from ECM memory. See CLEARING TROUBLE CODES .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.