Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Lexus ES 300FACTORY OEM SERVICE PROCEDURE
Bleeding Brake System
CAUTION:
Brake fluid will damage painted surfaces. If brake fluid contacts a painted surface, wipe off immediately and clean with alcohol. Use only DOT 3 brake fluid from a sealed container. Do not mix brake fluid with any other type.
- Brake bleeding procedure is same procedure used to bleed non-ABS systems. If master cylinder was rebuilt or reservoir became empty, bleed master cylinder first.
- Ensure master cylinder reservoir is full of brake fluid. Connect vinyl tube to caliper bleeder screw and insert other end of tube in a clear container 1/4 full of brake fluid.
- Slowly pump brake pedal several times. While depressing brake pedal, loosen bleeder screw until fluid starts to flow out, and then close bleeder screw. Repeat operation until no bubbles are present in fluid. Tighten bleeder screw to 96 INCH lbs. (11 N.m). See BRAKELINE BLEEDING SEQUENCE .
BRAKELINE BLEEDING SEQUENCE
| Application | Sequence |
|---|---|
| All Models | RR, LR, RF & LF |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.