1994 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Fuel Gauge System Test

NOTE: During testing, let the fuel gauge needle stabilize.
  1. Check fuel gauge sending unit. See FUEL GAUGE SENDING UNIT TESTΒ  under COMPONENT TESTING. If sending unit is okay, disconnect electrical connector from fuel gauge sending unit. Turn ignition on. Gauge should indicate empty.
  2. At harness side of sending unit connector, connect a 3.4-watt light bulb between terminals No. 2 and 3. See Fig 1. Gauge should indicate full and light should come on. If gauge indicates as specified, replace sending unit. If gauge does not indicate as specified, replace circuit plate. See Figure.
Fig 1: Testing Fuel Gauge
G93I01664Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.