1994 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Fuel Level Warning Light Switch Test

  1. Remove fuel gauge sending unit. Apply battery voltage across the following terminals of fuel gauge sending unit connector (sending unit side of connector).
  2. Connect a 3.4-watt test light between battery positive terminal and sending unit connector. Test light should come on after a few moments. Submerge entire sending unit (or fuel level sensor portion) in a container of fuel. Test light should go out. If operation is not as specified, replace sending unit.
Fig 1: Testing Fuel Level Warning Switch
G94F46974Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.