1994 Lexus LS 400FACTORY OEM SERVICE PROCEDURE

Check Valve (For Vacuum Control Circuit)

Remove check valve. See COMPONENT LOCATIONSΒ  under INTRODUCTION. Air should flow from Orange port to Black port. Air should not flow from Black port to Orange port. Replace check valve if it does not operate as specified. Install valve with Orange port toward VSV, and Black port toward vacuum source.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.