Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Lexus GS 300FACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Air Intake Chamber Bolts | 32 (43) |
| Air Intake Chamber Stay Bolts | 13 (18) |
| Distributor Hold-Down Bolts | 14 (19) |
| Fuel Pipe Banjo Bolts | 25 (34) |
| Fuel Rail Mounting Bolts | 15 (21) |
| Oxygen Sensor | 33 (45) |
| Throttle Body Nuts | 15 (21) |
| INCH Lbs. (N.m) | |
| Air Pipe Bolts | 65 (7.3) |
| Cold Start Injector Bolts | 69 (7.8) |
| Fuel Pump-To-Tank Bolts | 35 (3.9) |
| Fuel Rail Mounting Bolts | N/A |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.