1994 Lexus ES 300FACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System: Operation

The ABS functions as a standard brake system until the wheels lock. When the wheels lock, short pedal pulsations occur in rapid succession. This indicates that the system is operating. The vehicle will stop faster if you keep pressing the brake pedal with constant force.

When the ignition is turned on, an ABS indicator light on the instrument cluster will comes on for 3 seconds as a bulb test. A primary check is performed each time the engine is started, and when initial vehicle speed exceeds 4 MPH. If the brake pedal is pressed before the vehicle speed exceeds 4 MPH, the primary check will not occur until the brake pedal is released.

WARNING: Before servicing, read ANTI-LOCK BRAKE SAFETY PRECAUTIONS article in the GENERAL INFORMATION section.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.