1994 Lexus ES 300FACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System: Description

Anti-Lock Brake System (ABS) consists of an actuator, control relay (which consist of a solenoid relay and a pump motor relay), Electronic Control Unit (ECU), and a speed sensor at each wheel. If a system fault occurs, the ECU stores a self-diagnostic code(s) that can be retrieved to help find the problem.

NOTE: For more information on brakes, see BRAKE SYSTEM article in the BRAKES section.
ELECTRICAL COMPONENT LOCATIONS

Component Location
ABS Actuator (1) Right Front Corner Of Engine Compartment
ABS ECU Behind (Or Near) Right Kick Panel
Control Relay (1) On ABS Actuator
Data Link Connectors (2)
No. 1 Right Rear Corner Of Engine Compartment
No. 2 Behind Left Side Of Dash
Speed Sensors One At Each Wheel Hub
(1) See Figure.
(2) See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.