Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
Removal (ES300)
- Disconnect airflow meter connector. Disconnect air hoses. Loosen air cleaner hose clamp bolt. Disconnect air cleaner cover clips. Remove air cleaner cover and airflow meter together with air cleaner hose.
- Remove spark plug and coil wires. Disconnect distributor connector. Rotate crankshaft clockwise until No. 1 piston is at TDC of compression stroke. Ensure timing marks are aligned. Remove 2 hold-down bolts and distributor. Remove "O" ring from distributor housing.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
