1993 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Window Switch

CAUTION: Disconnect negative battery cable before removing power window switch.

Using taped screwdriver, carefully pry up on the forward end of power window switch assembly, releasing clip. Pull switch panel assembly forward. Unplug switch connector and remove switch assembly. Unclip and remove switch from panel. To install, reverse removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.