1993 Lexus GS 300FACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application Preferred Range
Camber (Degrees) Front -0.25 -1 to 0.5
Camber (Degrees) Rear -1 -1.5 to -0.5
Caster (Degrees) Front 7.08 6.33 to 7.83
Caster (Degrees) Rear N/A N/A
Toe-In (Inches) Front 0.04 0 to 0.08
Toe-In (Inches) Rear 0.16 0.12 to 0.2
Toe-In (Millimeters) Front 1 0 to 2
Toe-In (Millimeters) Rear 4 3 to 5
Toe-In (Degrees) Front 0.1 0 to 0.2
Toe-In (Degrees) Rear 0.4 0.3 to 0.5
Toe-Out On Turns Inner (Front) 38.75Β° N/A
Toe-Out On Turns Outer (Front) 32Β° N/A
Steering Axis Inclination (SAI) (Front) 8.83Β° N/A
Wheelbase Inches 109 7/16 N/A
Wheelbase Millimeters 2780 N/A
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.