1993 Lexus GS 300FACTORY OEM SERVICE PROCEDURE

Master Switch Test

Remove power window master switch. See WINDOW SWITCHΒ  under REMOVAL & INSTALLATION. Using an ohmmeter, check resistance of switch terminals with switch in indicated positions. If continuity is not as specified, replace switch. See Fig 1. See appropriate POWER WINDOW SWITCH CONTINUITY TESTΒ  table.

Fig 1: Power Window Switch Terminal ID
G93F83969Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
POWER WINDOW SWITCH CONTINUITY TEST

Position Switch Lock Terminal Continuity
Driver' Switch
Off (1) 3 & 4; 4 & 6
Up (1) 3 & 8; 4 & 6
Down (1) 6 & 8; 3 & 4
Right Front Switch
Off Unlock 4 & 11; 4 & 13
" Lock 11 & 13
Up Unlock 8 & 11; 4 & 13
" Lock 8 & 11
Down Unlock 8 & 13; 4 & 11
" Lock 8 & 13
Left Rear Switch
Off Unlock 4 & 12; 4 & 10
" Lock 10 & 12
Up Unlock 8 & 10; 4 & 12
" Lock 8 & 10
Down Unlock 8 & 12; 4 & 10
" Lock 8 & 12
Right Rear Switch
Off Unlock 4 & 7; 4 & 14
" Lock 7 & 14
Up Unlock 7 & 8; 4 & 14
" Lock 7 & 8
Down Unlock 8 & 14; 4 & 7
" Lock 8 & 14
(1) Lock switch position does not affect driver's switch operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.