1992 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Neutral Start Switch

Neutral start switch is located on side of transaxle. Turn ignition off. Disconnect neutral start switch connector. Using a DVOM, check for continuity between terminals specified in appropriate NEUTRAL START SWITCH CONTINUITY table. See Fig 1. If continuity is not as specified, replace neutral start switch.

NEUTRAL START SWITCH CONTINUITY

Range Continuity Between Terminals
P 2 & 3
P 9 & 1
R 9 & 4
N 2 & 3
N 9 & 6
D 9 & 5
2 9 & 7
L 9 & 8
Fig 1: Neutral Start Switch Terminal ID
G92E26116Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.