Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
Cold Start Injector (LS400): Removal
- Relieve fuel pressure. See FUEL SYSTEM PRESSURE RELEASEΒ . Disconnect negative battery cable and drain engine coolant. Remove air cleaner with airflow meter. Remove throttle body and left side engine wire harness cover. Disconnect ISC valve electrical connector, cold start injector connector, EGR VSV connector and EGR gas temperature sensor connector.
- Disconnect power steering idle-up hose from intake chamber. Disconnect brake booster hose from intake chamber. Disconnect PCV hose from EGR adapter, 3 vacuum hoses from air pipe, 2 vacuum hoses from EGR VSV and EGR vacuum modulator hoses. Remove EGR vacuum modulator. Remove air pipe. Disconnect coolant by-pass pipe.
- Remove accelerator cable and bracket. Disconnect cold start injector fuel delivery pipe. Disconnect EGR pipe from air intake chamber and remove gasket. Remove 4 bolts, 8 nuts, throttle cable clamp, 2 VSVs, check connector and air intake chamber.
- Disconnect cold start injector connector. Remove banjo bolt, cold start injector tube and 2 gaskets. Remove 2 bolts and cold start injector and gasket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
